ads' corner

Ansible: Just mount an existing filesystem

There is no easy way to “just mount” an existing filesystem in Ansible, using the mount module. I just want to mount an already defined mount point, and don’t really care about all the configuration here.


Ansible: copy a directory recursive - take two

Another slow attempt at copying directories and files on a remote system from one place to another, using just Ansible operations.


Install GNU parallel with Ansible

GNU parallel allows you to multiplex tasks, and possibly use more CPU resources to speed up the task at hand. This works if your task can be split down into multiple independent tasks which otherwise will be executed serially.


Certificate expiration date in Ansible

In one of my Ansible Playbooks I’m updating Let’s Encrypt certificates. Because the Playbook is rather long, I want to make sure that Ansible is not spending cycles on a certificate which is not about to expire. Hence I wrote a small filter plugin, which receives the certificate path and the number of days the certificate must be still valid.

This plugin is used to filter out any “good” certificate which does not need to be updated.


Ansible: copy a directory recursive

Recently I was looking for a way to copy a directory with all subdirectories, using Ansible. For reasons beyond this post I couldn’t use the synchronize (rsync) module. So I had to find a way to copy everything with basic Ansible steps.

That is possible, but it requires several steps, and it is very slow. Up to the point where it is not practical to use this approach for more than a few files and directories. Nevertheless, before moving on to another solution, I thought I document the steps here.


Weather Forecast in openHAB based on OpenWeatherMap, using Ansible

After setting up OpenWeatherMap in openHAB, I had another project on my list: send a forecast for the next day.

That is rather easy to do with a Cron rule.


Install OpenWeatherMap in openHAB, using Ansible

Next item on my home automation todo list: weather, and forecast. No good system without that data!

After exploring the options which openHAB supports, I settled for OpenWeatherMap. Note: you need an account with OWM, the basic functionality is free, the paid options give you more and better forecast.


Avoid "wear out" of SSD-cards in an openHAB system

You might know that problem: the brand new SSD in your system is super fast, but after a good time using it, the card is dead. Unlike spinning disks, which usually fail over time, and show I/O errors by blocks, SSD cards are prone to a problem called Wear leveling. Blocks which are written more often will “wear out”, and become unresponsible. More writes increase this risk. And a typical openHAB system does a number of writes all the time: every time an external status changes, it’s written to the event log. By default the syslog is written to disk as well, and then there is a myriad of systemd services, writing status information into files.


Configure a FRITZ!Box in openHAB, using Ansible

A while ago I posted about adding a Fritz!Box to openHAB, using Ansible. Now I had to use the Playbook to install another Raspberry, and found that some parts are missing in my posting. Mostly at the end, when it comes to configuring the Fritz!Box.

Therefore let’s run over all the steps again, and make sure that everything is covered.


openHAB: redirect port 8080 to port 80

The openHAB Raspberry image, by default, listens on port 8080. After using the image for a while, it became quite boring to always add the port to the URL. Quickly I decided to redirect port 80 to port 8080, and make my life easier.

Not sure how much work that is in the openHAB settings, I settled with redirecting or forwarding the port 80 to port 8080.